What are the installation methods of indoor LED display

What are the installation methods of the indoor LED display? The installation method of the indoor LED display is mainly determined according to the site environment. Usually, the area below 6 meters × 6 meters can adopt the frame structure. The LED module is directly adsorbed on the structural square with magnets. It can be wrapped by special profiles. If the area exceeds 36 square meters, it is recommended to weld it into a mesh structure with Fangtong. The LED display structure can be fixed on the wall first. If the entire LED display is fully installed, it is recommended to use aluminum-plastic panels or stainless steel to wrap the edges. . If the area exceeds 50 square meters, it is recommended to adopt the post-maintenance method. The front adopts a simple box structure, and the boxes can be spliced ​​together during installation. The disadvantage is that maintenance must be done from the back of the LED display. The thickness of the LED screen must be at least greater than 1250px. See It's not that ultra-thin.

Finally, we talk about the structure of the mobile LED display. The mobile structure was originally a simple box + aviation head structure, and later evolved into an LED display structure with a rear door box. Later, in order to reduce the weight of the LED display, it can be installed during installation. It is not so strenuous to lift up and transport, and the lightweight design has gradually derived the aluminum box structure. At present, the LED display of the die-casting aluminum box is the most widely used, which is beautiful and classy, ​​and the splicing gap is small. It can be hoisted and assembled on a day frame. It saves a lot of time for performance installation, and can also make greater profits for the rental market. .